• DepthAIHardware

  • Synchronization issues between the OAK-FFC4P module and the host clock

jakaskerl

Thank you for your suggestion. In fact, we try to do this.

However, the current radar uses PTPv2 to synchronize time with the host computer, and from the above results, he works very well.

In order to simplify the hardware design as much as possible, we would like to compensate for the fixed offset in the device.

At present, this offset value may be related to the hardware design? Does it perform the same on the same hardware? Maybe I could try to measure the offset first and then tell the device how to compensate.

Thanks，

Sky

      aiyangsky

      This also involves the synchronization problem of the IMU, which is known to be an integral system and very sensitive to time.

      We insisted that it was best to keep the whole system working on the same clock base as much as possible.

      Thanks，

      Sky

        jakaskerl

        @jakaskerl Yeah, I see all your devices are hardware synced using the FSYNC Y-adapter. I want to confirm, are the sensors connected to the FSYNC Y-adapter via external triggering?

        Thanks,

        Nav

            jakaskerl Using hardware synchronization does not resolve our issue, as the four cameras cannot achieve complete synchronization. For more details, please refer to the other post: https://discuss.luxonis.com/d/5879-oak-ffc4p-external-hardware-trigger-asynchronization-problem/2.

            We hope you can address this bug by implementing a software-based synchronization solution, where the cameras periodically sync with the main system clock. Thank you for your attention to this matter!

              jakaskerl

              hello, Jaka. I have carefully checked the API in depthai-core and found the settings related to host synchronization, but it does not work and the clock still drifts.

                jakaskerl

                I noticed that cam_B and cam_C share the iic bus, so their sampling is always synchronized. Can I make sure that the 4 Sensers are using the same CMOS by sharing the iic bus?

                Thanks,

                Sky

                    aiyangsky
                    AFAIK sharing the I2C bus will only affect the camera controls (3A and more) to be the same across all 4 sensors. The pairs still have separate clocks and separate FSYNC signals. Not sure if it's even possible to link more than 2 of the same sensors on the same i2c line (depends on how FW handles slave addresses) cc @Luxonis-Alex