@jakaskerl

1)

I dont have a poe switch. which switch would you recommend I buy in India?

2)
DEPTHAI_WATCHDOG_INITIAL_DELAY=60000 DEPTHAI_BOOTUP_TIMEOUT=60000 python3 manual_ip_program.py

[1844301091159D0F00] [169.254.1.222] [1740401482.048] [host] [warning] Watchdog initial delay set to 60000ms

Traceback (most recent call last):

File "/home/sarvesh/Desktop/depthai/manual_ip_program.py", line 28, in <module>

with dai.Device(pipeline, deviceInfo=device_info) as device:

     ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^

RuntimeError: Failed to find device after booting, error message: X_LINK_DEVICE_NOT_FOUND

    Sarvesh
    Don't know what is available in India specifically, but you usually can't go wrong with popular choices such as TPlink and netgear..

    I assume ping -I eth1 169.254.1.222 works

    Thanks,
    Jaka

      @jakaskerl Thank you.

      What should be the rating of the switch? I'm assuming a 5V 600 mA would be less right?

      Yes. The ping works.

        Sarvesh
        Specifically look for 802.3af standard or better (802.3at).

        Thanks,
        Jaka

          @jakaskerl i tried the above poe switch, but it still gave the same error.

          I also tried another dongle just in case but it still did not work.

          What could be the root cause?

            I connected the device to MacBook air where I have also installed Ubuntu and ran the calibration dump code like you recommended. Following picture shows the output:

              Hi Sarvesh
              I took another look at your initial post. Are you still using the ETH to USB dongle? If that is the case could you take a picture of it - it is probably the cause of the issue. I'd like to try to reproduce the issue with a similar dongle to check what can be done.

              If that is not the case, I am out of ideas as far as SW related issues go so I suggest we replace your device.

              Thanks,
              Jaka

                @jakaskerl I tried using three different dangles. It worked with neither.

                @jakaskerl I tried using three different dangles. It worked with neither.

                  Hi Sarvesh
                  Tested myself on a RPI5B with the USBA-ETH dongle and found no issues even with an injector. Leaves me no option but to attribute it to a HW issue.

                  Please write to support@luxonis.com so we can replace your device.

                  Thanks,
                  Jaka

                    Hi @jakaskerl

                    Thank you for continued assistance. I've sent an email. Please confirm if recieved.

                    6 days later

                    @jakaskerl I haven't yet recieved a reply to the email. Could you please contact your team?