Hi,
I have problem with it is heating when power up and when I try to connect to board it print message "Failed to find device after booting, error message: X_LINK_DEVICE_NOT_FOUND". When I disconnect the adapter with camera. The luxonis device is properly recognized.
I think that the resistors on board are heating

I think it is wired correctly. I also tried multiple adapter board with luxonis. All does not work properly

Where could be a problem? Thanks

  • erik replied to this.

    Hi oto313 , I'm not sure, just askedd the team internally so we should get back to you soon. Sorry about the inconvenience.

    Any progress? We are just in process of ordering 15 pcs and I do not want to have same problems.

    • erik replied to this.

      Hi oto313 , could you share which OAK model you are using (including HW revision)? There should be a text on the baseboard, like R0M1.... If it's the latest one, I believe you don't need the adapter in between, and you can just use the cable directly (using adapter will short 3v3 rail to gnd, and will heat up the voltage regulator).
      Thanks, Erik

      Ok. So your sales should give warning that you are ordering Luxonis with adapters that are useless. We almost ordered another batch of useless adapters. My luxonis version: DM1090FFC R3M0E2

      I tried the UC-796 cable but it does not fit in connector in raspberry pi HQ camera. The raspberry pi HQ camera has wider connector. Also raspberry pi camera cable does not fit to OAK-FFC. I dont know what else to try.

      • erik replied to this.

        Hi oto313 , we have just ordered the same camera module to our office so we can double check if this works as expected - we might have made a mistake, as these are quite old already. Will share additional info on email.
        Thanks, Erik