Hi, I saw on a separate thread here that code for enabling VBUS (well, vbus OUT rather) on a GPIO is of the form:
VBUS_OUT_GPIO_CTRL = 9
GPIO.setup(VBUS_OUT_GPIO_CTRL, GPIO.OUT, GPIO.PULL_NONE)
GPIO.write(VBUS_OUT_GPIO_CTRL, 1) # Enable 5V output
where 9 is the GPIO pin, but on the SJ2096POE board, I can't see which this would be on the GPIO mapping. Would it just be a matter of arbitrarily defining a pin, e.g. GPIO8 which is footprint pin 7 on the SPI header?, whereby the top line would become VBUS_OUT_GPIO_CTRL = 8
I need the board to provide power for some low-draw devices for a deployment scenario