OAK-D CM4 PoE

RyanLee

Hi,

I got oak-d cm4 poe. i am wondering that the firmware is empty when i get it from you?? So do i need to boot usb or usd (one of these)?? And what is the default ip addres of OAK-D CM4 PoE ??

Best regards,

Ryan.

jakaskerl

Hi RyanLee
The firmware (luxonis rpi OS image) comes preinstalled on every device. Some CM4s use EMMC storage (so the OS is flashed there) or SD card.

Here is a guide on how to start with CM4.

You can connect to the device using ssh pi@luxonis.local, or you can check your router for DHCP table.

Thanks,
Jaka

RyanLee

@jakaskerl

Thank you for your feedback. i have one more question. if i don't have dhcp, how can i connnect it using static ip??

Best regards,

Ryan.

jakaskerl

Hi RyanLee
I don't think it has a static IP. If you are on the same lan, use luxonis.local to connect to it. Then check the ip from within the device.

Thanks,
Jaka

RyanLee

@jakaskerl Hi

Thank you for your feedback. i find its ip address. But "ssh pi@luxonis.local -X" it is not working. i found ip address with ping (i tried from 1, 2, 3…..) so i found 192.168.0.3. and i connected it with "ssh pi@192.168.0.3 -X". But still i am wondering how can i found its ip address automatically because in our network many oak-d cm4 poe will be installed.

Best regards,

Ryan.