• OAK - D - POE Low FPS with Ubiquity 48 Volt POE Injector.

here is my setup. please have a look at .... I should have 30FPS but getting 7 FPS only.

here is the POE adapter

Please figure out the problem. Thanks!

  • erik replied to this.

    Hi SamiUddin ,
    Please have a look at PoE latency docs, and provide a report of all test results. This will help us figure out the problem.
    Thanks, Erik

      a year later

      My poe_test.py gives following output:

      mxid: 14442C1061D2EBCF00 (OK)

      speed: 1000 (OK)

      full duplex: 1 (OK)

      boot mode: 3 (OK)

      Oak bandwidth test- Downlink 874.1 mbps

      Uplink 278.0 mbps

      I get more fps on Oak-1usb and less fps on Oak-1 POE.

      Thoughts?

        Priyam26 I get more fps on Oak-1usb and less fps on Oak-1 POE.

        What FPS are you getting on both?
        It's normal to have less FPS on POE variants when using high resolution frames, because the USB3.0 has 5x as much bandwidth as CAT5E ETH.

        Thanks,
        Jaka

          On Poe I get around 20-22 fps while on USB-C I get around 38 fps.

          Hi @Priyam26
          That is expected and is a downside of using ETH devices.

          Thanks,
          Jaka