Sorry if this is question is too silly. Newbie here.
tl;rd I need to be able use the CM4 camera with my wireless router. Do you know any direct ways or have any drivers that work for you?
I recenty started using the OAK-D-CM4 and I am in a remote enough place that I don't have access to an ethernet port. But I do get a wireless signal from a company router.
I want to use my wireless dongle if the carrier board does not have WiFi modules, although I did see in the documentation that the CM4 Module has a Wireless module. But on the panel I see 'No wireless interfaces found'. (I tired a few simple tricks off of the internet but they don't seem to work.)
Are there any guides on how to ge the wireless set up going in my case?
Are there any drives I can look into for the TPLink AC1300 WiFi dongle I already have?
EDIT: I realized that there is a Broadcom chip onboard. Should I maybe just reset the Camera and try again? If so, how do I reset the Camera= I see the button, but whats the procedure?
Any update or direction would be much appreciated.
Thanks in advance,