Sorry if this is question is too silly. Newbie here. Hello, tl;rd I need to be able use the CM4 camera with my wireless router. Do you know any direct ways or have any drivers that work for you? I recenty started using the [OAK-D-CM4](https://shop.luxonis.com/collections/all-in-one-dev-kits/products/depthai-rpi-compute-module-4-edition) and I am in a remote enough place that I don't have access to an ethernet port. But I do get a wireless signal from a company router. I want to use my wireless dongle if the carrier board does not have WiFi modules, although I did see in the documentation that the CM4 Module has a Wireless module. But on the panel I see 'No wireless interfaces found'. (I tired a few simple tricks off of the internet but they don't seem to work.) **Are there any guides on how to ge the wireless set up going in my case? Are there any drives I can look into for the TPLink AC1300 WiFi dongle I already have?** EDIT: I realized that there is a Broadcom chip onboard. Should I maybe just reset the Camera and try again? If so, how do I reset the Camera= I see the button, but whats the procedure? Any update or direction would be much appreciated. Thanks in advance, Tarocal.

Hello @"tarocal"#p3375 , The RPi CM4 should have wireless connectivity. What's the serial number written on the CM4? As we can determine the model of the CM4 to be able to confirm whether it has wireless connectivity. Thanks, Erik

@"erik"#p3404 Hello, Next to the lens, under DEPTHAI, it has DM1097 R2M0E2. Just to confirm it once again, the RPi underneath has the BROADCOMS chip a well. Hope this helps, Tarocal.

Hello @"tarocal"#p3405 , We will debug it further in the start of the next week. Sorry about the inconvenience! Thanks, Erik

Can you please debug mine as well, I receive a message "No wireless interface found". DM1097 R2M0E2

Broadcom#2711ZPKFSB06C0T. I received the kit last week

Hello @"mohabsi"#p3418 , I have found that commenting out ``` # For OAK-CM4 to show uSD card #dtoverlay=sdhost,poll_once=off ``` Inside /boot/config.txt will fix this issue and you will be able to see WiFi interfaces. I am not sure what will be consequences (CM4 won't be able to use SD card? not sure), but I have yet to debug it. Thanks, Erik

It worked! Thanks much. I can live with this as a temporary fix.

Awesome, thanks for testing and confirming @"mohabsi"#p3438 !

Hi, @"erik"#p3436 I just received an OAK-D CM4 and have successfully connected via Ethernet, and it looks like #dtoverlay=sdhost,poll_once=off is already commented out in /boot/config.txt but I'm still getting "No wireless interface found" via sudo raspi-config. Do you have any other suggestions to try? Thanks

Hi @"kohani"#p6942 , Does the RPi CM4 have the WiFi module on it? I think the wireless module is marked with blue arrow, while eMMC is marked with red one. [URL=https://i.imgur.com/spTd5yL.jpg][IMG]https://i.imgur.com/spTd5yL.jpg[/IMG][/URL]

OAk-D-CM4 over Wifi (drivers)?

jakaskerl

Hi AnshumanFauzdar
https://stackoverflow.com/questions/76495004/installing-tenda-w311mi-usb-adabter-on-ubuntu-22-04

This was used to install the drivers. Perhaps consider re-running the commands.

Thanks,
Jaka

« Previous Page