• Hardware

  • What configuration would allow for IR dots stereo with an M12 FFC camera?

The only FFC camera module in the Luxonis store that supports IR is the OV9282, without M12. The OV9282-M12 claims to not support IR. I found that the Arducam OV9281 and its variants are IR-sensitive, with a potentially changeable M12 lens, but I'm uncertain if it would allow FSYNC and STROBE support to make use of the IR dot projector.

What are my options here?

Hi @zachjohnson
Can't say for certain if it will be detected at all. I guess if i2c and sensor are the same, then perhaps it can be - using the converter 26->RPI pinout. I'd say that likely, not much is changed from 9282 to 9281, so you might be good on the FSYNC and STROBE side as well.

Thanks,
Jaka