• Community
  • OverheatError: Temperature above 105C

Hi there!
After 1-2 minutes of running of depthai_demo.py I get overheat error: OverheatError: Temperature above 105C. Device will shutdown if not reduced
More details

  • Mac

  • OAK-D Lite

  • default settings for demo


    Why does this happen? Any ways to overcome?

  • erik replied to this.
    8 months later

    Just flashed the newest image on an SD-card, ran the demo and it crashed after about a minute with the same error. I am using the OAK-D Pro.

    Is there an image with a 64bit-system? And could you solve these kinds of problems in the forum and not bilateral, so the next person has the same issue?

    Hi FlorianBuchholz ,
    Is the OAK camera overheating, or the RPI? Could you share the full log?
    For the person above it was a hardware problem with some OAK-D-Lites (FF) which caused them to overheat, as enclosure wasn't tightly coupled with our SoC (RVC2), so heat dissipation wasn't good which caused the OAK-D-Lite to crash after a few minutes if full utilization.
    Thanks, Erik