Initially my 392-OAK-D-PRO-POE-FF camera was working fine by using IP address which was assigned when the camera was connected to the network. I tried using Static IP, but the due to improper static IP assignment, i was not able to detect the old IP. So, i did factory reset using programming board.

Now when i run code to find MXID, it displays no device found. My oakd device is not discoverable. Provide solution

@Haseena
I assume your OAK is still accessible through the M8 board. You have to select NETWORK bootloader when running a factory reset, otherwise the device will not have network functionality.
Can you ensure you have network bootloader flashed?

Thanks,
Jaka

8 days later

But after following the above steps still my device is not detected. Kindly reply

    Hi Haseena
    The flashing looks correct. Can you see lights on the ETH port when connecting it to a switch? If so, try booting the device using dai.device(pipeline) and not providing any MXID or IP.

    Thanks,
    Jaka

      I am not able to follow you. How to do without providing MXID or IP? Elaborate, if possible share the code and steps

      jakaskerl I am not able to follow you. How to do without providing MXID or IP? Elaborate, if possible share the code and steps

        Hi Haseena
        Just run the example script as is. Usually you can manually specify the IP or MXID of the device before connecting to it.

        Can you try using device_manager.py script? Maybe the script will be able to find your device.

        jakaskerl Can you see lights on the ETH port when connecting it to a switch?

        Thanks,
        Jaka