oak- ffc-1p POE doesn't work

Hi, ALL!

I'm struggle to make my oak- ffc-1p work in POE mode but I can't succeed.

It works in USB mode, everything's fine.

In POE mode no LED on RJ45 port lights at all and I got X-LINK error trying to connect.

I have tested a OAK-1 POE in the same PC, LAN, cables a.s.o. configuration and it works fine, too.

I have no idea, any lead welcome.

Waiting for answers, thx.

Alin

Could you try reflashing to the newest bootloader version and selecting NETWORK bootloader (instead of AUTO). This should flash the correct version.

Thanks,
Jaka

Jaka, thx for your prompt reply.

I already did it yesterday.

NETWORK bootloader wrote without error.

I set my preferred IP with no error confirmation.

But nothing is changet.

It's not working.

My concern is that no led on network rj45 connector.

I'm expecting to see the green LED lighting or flashing on the rj45 connector.

It isn't.

I have 2 identical boards, both behave the same.

Hi AlinDobrescu
What switch/injector are you using to power the cameras?
These are the requirements.

Thanks,
Jaka

Jaka,

I have ordered the PoE injector from Luxonis.

The same configuration works for oak-1PoE.

Jaka, hi!

I've tried again setting dynamic address and it works!!!

I'll double check to see what I was doing wrong.

Thank you very much for your support!

Best Regards,

Alin