Flashed a wrong network mask

saturnbass

I set up a network mask of 255.255.255.255 instead of 255.255.255.0 in an OAK-D PoE camera using the device_manager from Windows but now I cannot reach the device to fix it, due to this wrong contiguration.

I can't figure out any solution of this but factory reset, but before triying that I would rather ask if there is a better solution of this...

I've tried to set from windows network interface the netmask 255.255.255.255 and 255.255.255.0 and the same IP of camera or an IP within 255.255.255.0

jakaskerl

Hi saturnbass
I'm not sure how depthai will handle a 1 client subnet, but there are a few thing you could try:
1- Set your computer ip to one number away from device IP and set the PC's ipv4 settings (mask) to /32 as well and check whether you can establish direct connection with the device. If you can, change the mask back to /24

If that fails it's most likely you will need to perform a factory reset.

Thanks,
Jaka